Bottom View - SecuCare PR30330 Manual De Montaje

Assembly of Threshold Ramp
Carefully read the manual before starting the assembly.
Top view
If required, you can adjust the height of the SecuCare Threshold Ramp; you can lower the height of Set 1
by a maximum of 10 mm (in steps of 5 mm). Cutting lines are present in the plastic parts for this.
1
Determine the correct height.
3
If you have had to adjust the height of the sloping part, you will also have to modify the square
connector.
4
Place the connectors, square and rectangular, as depicted in the picture below. You can push them
in place with your hand, but you can also place the black plastic strike plate on the connector click
connection and tap it in place with a hammer. Make sure the surface underneath is solid and flat. Always
use the strike plate!

Bottom view

2
Cut to size.
9