Kathrein UFO 340 Manual De Instrucciones página 11

The desired parameter is selected with the " " and " " key.
This parameter is the same for both channel units. Settable in the submenu of Twin A or Twin B. There are three different
setting possibilities:
A/A = Twin A and Twin B are switched to input A
A/B = Twin A is switched to input A and Twin B to input B
B/B = Twin A and Twin B are switched to Twin B
This allows for the operation of channel units Twin A and Twin B on different polarities at the same time.
Note: Sat IF signals from different polarisation planes are to be connected to the inputs A and B with the same level
(tolerance ± 2 dB).
"RF on" or "RF off" can be selected with the "+" or "–" keys.
Switching off a channel unit causes it to shut down and no output signal is produced.
The setting of the output frequency (see below) and the level setting is only possible, if twin A is selected. This also
applies when the channel unit twin A is switched off.
If a channel unit is switched off, the main menu shows the following display:
Twin A
Outp. *Ch12
stereo
Vol 3 Vid 2
Main menu twin A (switched off)
The channel unit twin A can be used as a demodulator with A/V output (decoder interface) for the disengaged output
signal. All parameters for channel unit twin A are still displayed, and the output channel display is marked with a *
(indicator for disconnected output signal).
3. Selecting the input frequency
Twin A
Outp. Ch12
stereo
Vol 3 Vid 2
4. Selecting the output frequency or output channel
Twin A:
Outp. Ch12
Stereo
Vol 3 Vid 2
Main menu
All manuals and user guides at all-guides.com
1744 MHz
or
224.25 MHz
7.02/7.20 MHz
AV
The input frequency is selectable in 1 MHz steps between
950 MHz and 2150 MHz with the "+" or "-" key.
1744 MHz
224.25 MHz
Changing the entry by numeric character entry is also possible:
Press and release the " " and " " keys at the same time
7.02/7.20 MHz
(mode starts).
AV
Select the position with the " " and " " keys
(the selected position flashes).
Set the position with the "+" or "-" key.
In this manner, all the positions are selected and set.
Press and release the " " and " " keys at the same time
(mode ends).
1744 MHz
224.25 MHz
7.02/7.20 MHz
AV
Twin B
Main menu twin B (switched off)
*** UFO 340
Outp. freq.
Outp. level -12
< Return:
Submenu output
OFF
***
224.25 MHz
Standard B/G
Submenu.. >