InSinkErator C1300 Instalacion, Cuidado & Uso página 6

3
MOUNTING THE TANK
A
Property Damage: Tank must be located within 16" of
faucet and within 30" or less of a standard grounded
outlet. DO NOT extend plumbing or electrical lines.
B
Leave 1/4" for
hanging tank.
Mount tank vertically in an area that
allows clearance on the underside of the
tank for drainage, if necessary.
DO NOT over tighten screws.
4
CONNECTING FAUCET TO TANK
A
1
Property Damage: Pinched or blocked water lines
may cause damage to the dispenser tank.
B
Property Damage: Check to make sure
tubes are connected properly and are
pushed in as far as possible.
6
All manuals and user guides at all-guides.com
Tank must be
mounted level
to ensure
proper operation.
2
3
■ ■
Select a spot under the sink to mount
tank vertically within reach of both
plumbing and electrical connections.
The tank should be within 16" or less
of faucet water lines and within 30"
or less of a standard grounded outlet.
■ ■
While holding tank in place on
the spot selected for installation,
use a pencil to mark locations for
2 hanging screws.
Screws provided are for use in wood
studs or cabinets only. Use wall anchors
(not supplied) for installation into drywall.
■ ■
Pre-drill 1/8" pilot holes at marks.
■ ■
Turn screws into pre-drilled holes,
leaving 1/4" exposed.
■ ■
Hang the tank on the screws.
■ ■
Tighten the screws with only 1/2 turn
clockwise.
■ ■
Without depressing the gray button,
place the snap-connect fitting at
the end of the blue 1/4" tube onto
the left plastic fitting on the tank,
pushing until it clicks into place. (1)
■ ■
Slip the flexible white 7/16" tube
over barbed middle fitting and slide
down approximately 1/2". (2)
■ ■
Slip the clear 5/16" tube over the
far right smooth fitting and slide
down approximately 1/2". (3)
■ ■
Visually check for pinched or
crimped tubes.