Key Definitions; Charging The Bark Control Collar - Petsafe HBC11-14014 Manual De Funcionamiento

Key Definitions

Digital Display: Displays the current
correction mode based on light
color(s) and the numeric indicator. Also
indicates the condition of the battery.
Settings Button: Adjusts the correction
mode and the level of correction your
dog receives when barking. Also used
to turn the Stubborn Dog Bark Control
collar on and off.
Contact Points: Deliver the static correction.
Vibration Sensor Probe: Detects the vibrations of your dog's barking.
Charging Jack: For connecting the charging adapter. Although the bark control unit is
waterproof, keep the cover in place when not charging to keep debris out of the opening.
Sound-Activated Sensor: Detects your dog's bark.

Charging the Bark Control Collar

Before using the PetSafe
the unit by following the steps described below.
Follow these steps to charge the battery:
1. Lift the rubber cover protecting the Charging Jack.
2. Connect the charger connector to the Charging Jack.
3. Plug the charger into a standard wall outlet. The display light will flash the sequence Green-
Blue-Red to indicate that charging has started.
4. During charging, keep the Bark Control collar in an open, well-ventilated area. The display
light will flash red twice every 10 seconds to indicate that charging is active.
5. When charging is complete, the charger will automatically shut off, preventing overcharging.
The display light will flash green twice every 10 seconds to indicate that charging is
complete. Note: The battery should fully charge in less than 4 hours.
6. Remove the charger from the Charging Jack. The light will flash the sequence Red-Blue-
Green to indicate the unit is no longer charging.
7. When charging is complete, replace the Charging Jack cover and unplug the battery charger.
The Stubborn Dog Bark Control collar will automatically turn off when the battery charger is
connected. Following a charge, turn the unit back on before using.
Note: When the unit indicates that the battery is low (battery icon on the display indicates 1 bar
or less and/or the light flashes red 3 times every 5 seconds) it is time to recharge the unit. If the
battery pack is very low (i.e. been used too long or stored for an extended period of time) it may
take some time for the unit to indicate that charging has started. If the unit does not indicate
that it is charging after 1 hour, please contact our Customer Care Center.
6
Digital Display
Stubborn Dog Bark Control collar for the first time, be sure to charge
®
Customer Care Center 1-800-732-2677
(Top)
Settings
Button
Contact Vibration
Points Sensor Probe
(Bottom)
Charging Jack
(charger attached)
Sound Activated Sensor