Functional Description - Black and Decker LCSB2140 Manual De Instrucciones

in a warm environment such as in a metal
shed, or an uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by
plugging in a lamp or other appliance.
b. Check to see if receptacle is connected
to a light switch which turns power off
when you turn out the lights.
c. Move charger and battery pack
to a location where the surrounding
air temperature is approximately
60°F - 80°F (16° - 27°C).
d. If charging problems persist, take
the tool, battery pack and
charger to your local service center.
4. The battery pack should be recharged
when it fails to produce sufficient power
on jobs which were easily done previously.
DO NOT CONTINUE to use under these
conditions. Follow the charging procedure.
You may also charge a partially used pack
whenever you desire with no adverse
affect on the battery pack.
5. Foreign materials of a conductive
nature such as, but not limited to, steel
wool, aluminum foil, or any buildup of
metallic particles should be kept away
from charger cavities. Always unplug the
charger from the power supply when there
is no battery pack in the cavity. Unplug
charger before attempting to clean.
6. Do not freeze or immerse charger in
water or any other liquid.
WARNING:
SHOCk HAzARD. Do
not allow any liquid to get inside charger.
Never attempt to open the battery pack
for any reason. If the plastic housing of
the battery pack breaks or cracks, return
to a service center for recycling.

fUNCTIONAl DESCRIpTION

1. Handle bar
2. ON/OFF switch bail handle
3. Safety key
4. Safety switch button
5. Chute rotation rod handle
6. Frame lock/release knob (x4)
7. Battery compartment cover
8. Wheels
9. Carrying handle (For transport only)
10. Discharge chute
11. Chute deflector / guard
12. Deflector knob
13. Auger
14. Middle frame
15. Upper frame
16. Clean out stick
All manuals and user guides at all-guides.com
STATE Of CHARGE INDICATOR
The battery is equipped with a state
of charge indicator. This can be used
to display the current level of charge
in the battery while in the mower and
during charging. It does not indicate
tool functionality and is subject to
variation based on product components,
temperature and end-user application.
Checking state of charge during use:
• Press the state of charge indicator
• The threev LEDs (1b) will illuminate
• If LED light does not illuminate, charge
4
5
14
7
button (1a).
indicating the percent of charge in the
battery. See chart in figure 1.
battery.
1
1b
1
2
15
3
6
7
12
8
10
1a
<18%
18% - 45%
45% - 72%
72% - 100%
9
11
16
13