WAGNER SIDNEY Manual De Instrucciones página 9

SIDNEY
INSTALLATION
Choose a site for installation with as much irradiation as possible. Do not place the
SIDNEY in the shade of trees, bushes or buildings, as this will greatly reduce the
degree of efficiency of the SIDNEY.
PERFORMANCE
The performance of your SIDNEY depends on the time of year. SIDNEY is ready for
operation longer in summer than in winter.
How long SIDNEY shines at night depends on how long SIDNEY was exposed to direct
solar radiation during the day. For example, when the sky is overcast, less solar energy
is available to load the rechargeable battery. During the following night, the duration of
emission of light of SIDNEY is therefore shorter.
The duration of emission of light is strongly limited on winter days due to lower exposure
to solar radiation.
NOTE: Clean the solar module regularly with a damp towel to guarantee
optimum performance of the solar collectors. Do not use any
solvents for cleaning. Do not put any pressure on the solar module
during cleaning.
FAILURE CORRECTION
If SIDNEY should fail to function despite observance of all instructions, please proceed
as described in the following steps :
1) Turn the selector switch several times to the positions „OFF" and „ON".
2) It may occur that your SIDNEY is ready for operation but it is covered by
another source of light. In this case, relocate the solar station.
3) Ensure that your SIDNEY does not stand in the shade during the day.
4) Check the rechargeable battery for corrosion.
REMOVING / CHANGING THE RECHARGEABLE BATTERY (4 - 6)
Manually turn the solar module-counter-clockwise in order to seperate it from the
●
lamp unit .
Lay the solar modul face down.
●
Remove the cover of the rechargeable battery
●
Remove the rechargeable battery to re-load it and/or exchange it
●
Re-assembly is accordingly conducted in the reverse order.
ATTENTION: 1) When removing/replacing the rechargeable battery, the
selector switch must be in position „OFF".
2) Use Original WAGNER rechargeable batteries only.
3) When inserting batteries, make sure the polarity is correct (+/-)
All manuals and user guides at all-guides.com
.
.
GB
5