Silhouette DWC283BLS Manual Del Propietário página 4

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DOOR REVERSAL
TOFACILITATE
DOOR REVERSAL,
WERECOMMEND
SOMEONE
ASSIST YOU DURING THIS PROCESS.
TOOLS R EQUIRED:
PHILLIPS SCREWDRIVER
1_Lay
the unit in it's back,
2, Remove the three (3) screws from the bottom hinge, Remove the bottom hinge
NOTE:
Keep this hinge in a safe place in the event you ever need to revert back to a dght hand door swing.
3. Remove the door from the cabinet and carefully set aside
4_ Remove the two (2) plastic screw covers located on top of the hinge cover
5. Remove the screws holding the hinge cover to the top hinge,
6. Remove the three (3) screws from the top hinge
7, Remove the top hinge
8
Remove the three (3) plastic screw covers from the top left side of the cabinet.
9, install the top hinge on the left side of the unit and secure with three (3) screws.
10. Install the hinge cover back on the top hinge
11, Install the two (2) plastic screw covers on the hinge cover
12. Install the three (3) plastic screw covers to the top right hand side of the cabinet,
13. Carefully install the door on the cabinet° (Insert upper door into top hinge pin)
14. Using the left hand bottom hinge supplied with your unit, insert the hinge pin into the bottom of the door.,
(Align the hinge holes with the holes in the cabinet, and secure to cabinet with three (3) screws,
I54 Check alignment of door and door seal before tightening screws.
16. Tighten all hinge screws,
17 Place unit in the upright position.
NOTE: Allow the unit to stand upright for 1 hour before putting the unit into operation,

Publicidad

Tabla de contenido
loading

Tabla de contenido