Technical Information; Envisaged Use - Black and Decker PW1300TDW Instrucciones Originales

Danger sign, warns users not to direct the water jet at people,
animals, elec- trical equipment or the product itself.
Not connect to potable water.
Warning! Safety signs. Comply with the instructions
provided by the safety signs ted to the appliance. Check
that they are present and legible; otherwise, replacements
in the original positions.

TECHNICAL INFORMATION

ENVISAGED USE

This appliance has been designed for individual use for
the cleaning of vehicles, machines, boats, masonry, etc, to
remove stubborn dirt using clean water and biodegradable
chemical detergents.
Vehicle engines may be washed only if the dirty water is
disposed of as per regulations in force.
f Intake water temperature: See data plate on
the appliance.
f Intake water pressure: Below 10 bar.
f Operating ambient temperature: Above 0 °C.
The machine complies with the IEC.
OPERATOR
The symbol on the front cover identifies the appliance's
intended operator (professional or non-professional).
MAIN COMPONENTS (Fig. A)
The machine is delivered partially disassembled
in a carton.
1. Pressure washer
2. Power supply cable with plug
3. Handle
4. High pressure hose
5. Lance
6. Adjustable lance
7. Adjustable spray nozzle
8. Gun with safety catch
9. Safety devices
10. Nozzle cleaning tool
11. Detergent kit
Caution! Safety devices:
Do not tamper with or adjust the safety valve setting.
f Safety valve and pressure limiting valve:
The safety valve is also a pressure limiting valve.
When the gun trigger is released, the valve opens
and the water recirculates through the pump inlet or is
discharged onto the ground.
f Safety catch (9): prevents accidental spraying of water.
ASSEMBLY
Caution! All installation and assembly operations must
be performed with the appliance disconnected from the
mains power supply.
The assembly sequence is illustrated in Fig. C.
Electrical connection
Caution! Check that the electrical supply voltage and
frequency (V-Hz) correspond to those on the appliance
data plate Fig. B. The appliance should only be connected
to a mains power supply equipped with an adequate earth
connection and a d erential security breaker (30mA) to cut
off the electricity supply in the instance of a short circuit.
Use of extension cables: Use cables featuring "IPX5"
protection level. The cross-section of the extension cable
should be proportionate to its length; the longer it is, the
greater its cross-section should be. See Fig. G.
Water supply connection
Caution! Only clean or teredwater should be used for
intake. The delivery of the water intake tap should be equal
to that of pump capacity. Place the appliance as close to
the water supply system as possible.
Connection points:
Water outlet (OUTLET)
Water inlet with filter (INLET)
Connection to the mains water supply
The appliance can be connected directly to the mains
drinking water supply only if the supply hose is fitted with
a backflow preventer valve as per current regulations in
force. Make sure that the hose is at least Ø13mm and that
it is reinforced.
Connecting to the mains water system/water supply
Detergent flow is adjusted using the regulator.
Warning! Comply strictly with the technical regulations
and standards of the local water supply company.
f Ensure that the water mains connection complies
with the data provided in the appliance's technical
specifications.
f Connect the water supply hose (not supplied)
to the appliance's intake connection (Fig. C).
f Turn on the water supply.
f Vent the air from the appliance. To vent the air from
the appliance, set the nozzle in low pressure mode
(Fully forward) and press the trigger (First releasing
the safety catch (9) if necessary) until the water which
flows out is free from air bubbles. When done, return
the nozzle to the high pressure setting.
ENGLISH • 15