Troubleshooting - Overmax Multipic 5.1 Manual De Usuario

Restoring factory settings
Select „Settings" > „Popular" > „Factory settings" (fig. 15).
Keystone effect settings
If you position the projector non-parallel to the wall, the image will be displayed
in the shape of trapezoid. The image may be adapted both vertically and
horizontally by shortening and spreading sides and corners (fig. 16, 17).
Zoom settings
It is possible to adapt the zoom effect to your preferences (fig. 18).
Supported formats
Video formats: 3GP/AVI/FLV/MP4/MPG/VOB/TS/M2TS/DAT/MKV
Audio formats: MP3/APE/AAC/FLAC/OGG/WAV/WMA/MID/DTS/M4A
Image formats: BMP/JPG/PNG/JPEG
Note: this device does not support sound coded in Dolby system due to
copyrights protection.

Troubleshooting

Problem
1. The projector does not work when
power is on
2. The projector does not work
when you are using a remote
control
Possible causes
Power cord is not correctly
connected
On/off switch is damaged
Remote control has no batteries or
batteries are flat
Remote control is pointed at
infrared receiver (2)
Infrared receiver (2) is highly
illuminated
Input source may be incorrect
EN