ZAMST FILMISTA WRIST Instrucciones De Uso página 2

1.
Unfasten all the hook-and-loop fasteners of the product. Confirm the top/bottom and inside/outside of the product.
Strap A
<Outside of the product>
2.
Slide the adjustment belt, and pass the hand through the product from the side with the logo mark.
3.
Make sure the belt loop is in line with the middle finger, adjust the strap A, and fasten the hook-and-loop fastener A.
Belt loop
4.
Adjust the strap B and fasten the hook-and-loop fastener B.
Strap B
5.
Make sure that the product is not loose or out of place. If you feel any discomfort, repeat the steps from the beginning to
reattach the product.
Reporting Obligation
If you have any complaints about the product, please contact your medical retailer directly. It is only necessary to notify the manufacturer and the competent authority of
the member state in the event of any serious incidents that could lead to a significant deterioration of health or to death. Serious incidents are defined in Article 2 No. 65 of
Regulation (EU) 2017/745 (MDR).
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
Logo mark
Adjustment belt
Pass the hand through the product
Strap A
Hook-and-loop
fastener B
The product correctly fastened (right hand)
<Back of hand>
Tag
<Inside of the product>
Hook-and-loop fastener A
Adjust the strap B so as not wrinkle the product, and fasten the
hook-and-loop fastener B.
<Side view>
Confirm the positioning of the product
by checking the direction of the arrow on
the tag. Strap A will be positioned closer
to the hand and the logo mark faces the
front side.
Logo mark
With the hand open, pull the strap A to
the little finger side (in the case of the left
hand, thumb side), make sure it fits tightly
on the wrist, then fasten the hook-and-
loop fastener A. Be careful not to turn the
product at the time.
<Palm of hand>
EN