Avoid Prolonged Exposure To Vibration; 90 Psig Maximum; Use Only Recommended Chisel Attachments - john deer AT-3701-J Manual De Operación

All manuals and user guides at all-guides.com

AVOID PROLONGED EXPOSURE TO VIBRATION

Pneumatic tools can vibrate during use. Prolonged exposure
to vibration or very repetitive hand and arm movements, can
cause injury. Stop using any tool if discomfort, tingling feeling
or pain occurs. You should consult your physician before
resuming use of the tool.

90 PSIG MAXIMUM

Designed to operate at an air pressure of 90 pounds per square
inch gauge pressure (90 PSIG) maximum, at the tool. Use of
higher air pressure can, and may cause injury. Also use of
higher air pressure places the internal components under loads
and stresses they were not designed for, causing premature
tool failure.
NOTE: The air supply should be clean and dry, preferably
lubricated. For best results drain the moisture from your
compressor daily.
USE ONLY RECOMMENDED CHISEL
ATTACHMENTS
Use tool only after inspection of chisel, retainer, and hoses.
Repair or replace worn items before use. Use only accessories
that are hardened steel and the correct size for the tool.
6
WARNING
CAUTION
Air Hammer Operator's Manual