Uline H-6897 Instrucciones De Montaje página 2

4. Place first piece of three-piece shelf on top of rails
with flush side facing up. Bolt first piece to shelf rails
using two short hex head bolts. Bolts will go through
shelf rails and into threaded holes in shelves. Repeat
for the next two shelf pieces. (See Figure 3)
Figure 3
NOTE: Shelves can be installed with one-way
security bolts (included) for additional security,
instead of short hex head bolts.
WARNING! The one-way security bolts can be
installed normally, but cannot be removed.
These security bolts are a PERMANENT security
solution that cannot be undone.
ADD-ON UNIT ASSEMBLY
1. Bolt add-on unit door frame to starter unit door
frame by inserting three long hex head bolts through
open holes in one door frame and into threaded
hole in other door frame. (See Figure 4)
Figure 4
2. Bolt side panel to door frame by inserting four
short hex head bolts through side panel holes into
threaded holes in door frame. (See Figure 5)
PAGE 2 OF 15
ASSEMBLY CONTINUED
3. Bolt shelf rail to inside of shared side panel flange using
two longer carriage bolts and two nuts. (See Figure 6)
4. Place first piece of three-piece shelf on top of rails
with flush side facing up. Bolt first piece to shelf rails
using two short hex head bolts. Bolts will go through
shelf rails and into threaded holes in shelves. Repeat
for the next two shelf pieces. (See Figure 7)
5. Tighten all bolts and nuts fully.
Figure 5
Figure 6
Figure 7
NOTE: Shelves can be installed with one-way
security bolts (included) for additional security,
instead of short hex head bolts.
WARNING! The one-way security bolts can be
installed normally, but cannot be removed.
These security bolts are a PERMANENT security
solution that cannot be undone.
1120 IH-6897