Maintenance - Ryobi P727 Manual Del Operador

TO HANG THE WORKBENCH LIGHT
See Figures 3 - 5, page 8.
WARNING:
Only hang or mount LED work light in an area where no
electrical wires, utility cables, pipes, or other obstructions
are located. Contact your local utility company or a
qualified electrician if you are unsure. Do not hang work
light from any electrical power cord. Ensure work light is
securely installed to prevent falling object hazard. Failure
to follow these instructions can result in electrocution,
electrical shock, or other serious personal injury.
Using the J hook to hang the work light:
 Fold the workbench light in half at the joint as shown.
 Lift the J hook from the slot.
 Use the J hook to hang the workbench light. You may
use a screw to secure the workbench light in place. Do
not overtighten.
NOTE: Be careful not to hang the workbench light in
such a way that it prevents normal workbench light
operation.
Using the mounting holes to hang the light:
 Unfold the workbench light to a straight position as
shown.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
STORING THE WORKBENCH LIGHT
Store indoors in a dry, locked up place—out of the reach
of children with the battery pack removed and power cord
disconnected. Keep away from corrosive agents such as
garden chemi cals and de-icing salts.
NOTE: ILLUSTRATIONS START ON PAGE 7
AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
 Lift the mounting brackets as shown and hang the
workbench light from a sturdy location using the
screws in the mounting holes to secure in place. Do not
overtighten.
NOTE: Be careful not to hang the workbench light in
such a way that it prevents normal workbench light
operation.
Using the hooks in the mounting hole brackets to hang
the light:
 Unfold the workbench light to a straight position as
shown.
 Pull out and flip up the hooks from the mounting bracket
and use the hooks to mount the light
NOTE: Be careful not to hang the workbench light in
such a way that it prevents normal workbench light
operation.
ADJUSTABLE HEAD
See Figure 5, page 9.
CAUTION:
Do not place hands or fingers between adjustable head
and frame when positioning workbench light to avoid
pinching your fingers or hands.
The workbanch light head can be set in a variety of positions.
To switch positions, adjust head to desired position.

MAINTENANCE

GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
6 – English