Troubleshooting - Tassimo TAS 6512CUL Manual Del Usuario

16

Troubleshooting

Problem
no symbols light up.
I cannot read the LC
display because it is in
the wrong language.
Machine brews but no
O
Automatic mode
remains in stand-by
mode.
More Customer Service information is available online at www.tassimopro.com
TAS6512CUL_090805.indd 16
All manuals and user guides at all-guides.com
The following table provides solutions for problems and glitches
that may arise as you use your TASSIMO PROFESSIONAL
or the problem persists after troubleshooting please contact
TASSIMO PROFESSIONAL Customer Service at 1-888-MYT-
DISC.
!
Note: If piercing unit is missing, it may be purchased
from TASSIMO PROFESSIONAL at 1-888-MYT-DISC or only
in the USA on www.tassimopro.com.
Possible cause
There is no power supply.
You may want to change the
language setting.
during the brewing process or
there is air in the system.
No T DISC inserted.
The barcode could not be
detected.
Solution
properly plugged into the
power supply.
Please proceed as described
in the section "Controls and
displays".
appropriate position in your
TASSIMO PROFESSIONAL
machine. Start a cleaning
process with the Service
T DISC.
inserted.
Clean the bar code reading
window and try again or
smooth the barcode on the
T DISC out with your thumb.
Use another T DISC.
If problems persist contact
TASSIMO PROFESSIONAL at
1-888-MYT-DISC.
EN
11.08.2009 14:27:16