Select Base - Daewoo International DTD 1600 Manual De Instrucciones

CONTRAST
key. Using ∧ ∧ ∧ ∧ or ∨ ∨ ∨ ∨ key to select CONTRAST
1) Press
2) Press key, LCD will display CONTRAST 5
3) Using ∧ ∧ ∧ ∧ or ∨ ∨ ∨ ∨ key to select appropriate contrast
4) Press key to confirm.

SELECT BASE

The handset can be registered to more than one base (up to a maximum of 4), and you can select which
base you want the handset to operate with.
key, then using ∧ ∧ ∧ ∧ or ∨ ∨ ∨ ∨ key to choose SELECT BASE.
1) Press
2) Press key and the LCD displays BASE 1 + .
3) Press ∧ ∧ ∧ ∧ or ∨ ∨ ∨ ∨ to select base (BASE 1~4) or AUTO.(Note: the handset will only link with base number
followed by a "+")
4) Press to begin searching, if you hear a sound of "di-du-di", means linked successful.
NOTE: If you select "AUTO", the handset will link with the first of the registered bases that it finds.
HANDSET DEFAULT :
This function allows the user to restore the handset setting to the factory default
key, then using ∧ ∧ ∧ ∧ or ∨ ∨ ∨ ∨ key to select HS DEFAULT item.
5) Press
6) Press key to confirm.
7) The display shows PIN?, then key in the PIN code (default 0000).
8) Press to confirm. If the PIN code is validated handset settings will be returned to the factory default.
Handset Menu function 5: REGISTRATION
This function allows the user to register the handset to a specified base.
Before registering a handset to the base, the base should first be put into subscription mode, by pressing and
holding the (PAGE) key for 5 seconds, the base IN USE/CHARGE LED flashing.
key, then using ∧ ∧ ∧ ∧ or ∨ ∨ ∨ ∨ key to select REGISTRATION item.
1) Press
2) Press key to enter.
3) Press ∧ ∧ ∧ ∧ or ∨ ∨ ∨ ∨ key to select BASE names. (If the handset already has a registration to the base, there is a
"+" on the right side of the display, and you should choose another base number if you don't want to lose
that one)
4) Press key to confirm, the display shows PIN?, key in the 4 digit PIN code for the base (the default
PIN code is 0000)
5) Press key to confirm, and the display will flash "SEARCHING 1"(or 2,3,4)
If the base is not found, the handset will return to the previous registration state.
If have several handsets, repeat the above steps to register another handset, and the successfully
registered handset will displays HS2 or HS3 on the LCD according to the registration sequence.
NOTE: Press key to page the handset when difficult to look for. Press
All manuals and user guides at all-guides.com
28
key again to stop.