Varan SPT-15103 Manual De Utilización página 22

Note: Apply PTFE tape tightly and in a clockwise direction, so it does not come off when the
thread is screwed into the tool.
Remove the protective plug from the air inlet
2.
Using a spanner (not included) screw the quick connector into the air inlet located at the base
3.
of the handle
Connect to airline, pressurise carefully and carry out a leak check (e.g. by spraying small
4.
amounts of soapy water on to the outside of the connectors)
Air lines fitted with matching female quick connectors will now be a push fit to the tool
Air supply connection
NIPPLE
TO YOUR AIRTOOL
LEADER HOSE
This tool should be connected to a clean, dry air supply with inline oiler and water separator
• Do not allow supply pressure to exceed the maximum stated (see "Specifications")
• Ensure that water is drained from air system daily
• Ensure that all parts of the system (hoses, couplers, etc.) are correctly rated for the air pressure
to be used
Setting tool power
• The maximum tool speed/power can be adjusted by reducing/increasing the air supply pressure
within the range specified in 'Specifications'
• Whilst working with the tool, speed adjustments can be made via the Speed Control Trigger (9)
Fitting a cutting disc
WARNING: Always disconnect the tool from the air supply before fitting or removing a cutting disc.
Slot the Spanner (7) over the Spindle (3) so that it grips the two flat faces (see Fig. I). The spindle
1.
should be held securely and not able to rotate
Use the Hex Key (6) to unscrew the Bolt & Flange (4)
2.
Remove the disc if in place
3.
Fit a new disc of correct size (see 'Specifications'), following the manufacturer's guidance for direction
4.
of rotation
Note: Unless otherwise stated, the metal ring at the centre of the disc should face the Spindle (3).
Refit the Bolt & Flange (4) in the correct orientation (Image A), ensuring it is not deformed, burred or
5.
notched, and tighten using the spanner and hex key
WARNING: A damaged flange may cause irregular pressure on the disc, and may cause it to break.
WARNING: DO NOT overtighten. The direction of rotation will prevent the bolt from becoming loose.
Spin the Cutting Disc (5) by hand to check it is secure and correctly aligned
6.
Varan Motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
QUICK COUPLER
NIPPLE
RECOIL HOSE
WATER SEPARATION
OILER
REGULATOR
T: 00352/26908036 – F: 00352/26908040
SPT-15103
SPT-15105
DRAIN DAILY
AIR SUPPLY