En Glass Wall Mounting Instructions - EVOKO NASO Manual Del Usuario

EN
IMPORTANT!
Read the safety instructions carefully before using the mounting instructions!
For mounting on smooth glass surfaces only!
Make sure the surfaces are clean, dry and above 15°C / 59°F before mounting!
Avoid mounting in direct sun light!
1. Start by cleaning glass wall surface with alcohol and let the surface be completely dry. Recommended room
temperature during this operation is min 15°C / 59°F. Apply a horizontal adjusted tape on the glass wall as a guide for the
adhesive foil. Height from floor to top of device approximately 1600 mm / 5.25 ft.
2. Remove the protective film partly from the glass wall adhesive foil.
3. Press the foil on to the glass wall with a force of approximately 3 kgf. Use a rubber roller or scraper for this operation.
Make sure to remove any trapped air bubbles.
4. Remove protective film from the back plate.
5. Decide on the direction you want to exit the cables and make sure the hole for the cable exit is facing this direction.
Use the screw holes and the crosses on the wall sticker to get the right alignment.
Note! The glue will bond immediately, and cannot be remounted.
6. Press mounting bracket into glass wall foil for 20 seconds by a force of approximately 6 kgf. Leave bracket on glass
wall for 20 min before final assembly.
7. Route the cables through the appropriate cable channels on the device.
8. Mount the device on the bracket by fitting the talons on the back plate with the holes in the device and gently turn it
clockwise to snap it in place.
9. Secure it by screwing out the screws to be flush with the wall mount. One on the same side as the cable outlet and
the other on the opposite side.
Glass wall mounting instructions
For the latest instructions go to: www.evoko.se/downloads
6