Humanscale NeatCharge Instrucciones De Montaje página 3

NOTE
Charger does not work at close range. The work
surface thickness must be at least 15mm (0.6")
and no more than 34mm (1.3").
Devices with MagSafe may experience a reduction
in maximum charging range of up to 5mm (0.2")
STEP 1:
Locate the desired position for the charger on
the surface. Measure from there to the edges of
the surface.
STEP 2:
Find the same location beneath the surface.
Ensure that there is adequate room to mount
the charger and adjust position if necessary.
①
②
③
3