LUND LN28565038 Instrucciones De Instalación página 3

7. Level and adjust the Running Board and tighten all hardware at this time.
8. Repeat Steps 2—7 for Running Board installation on the passenger side.
9. Do periodic inspections of the installation to make sure that all hardware is secure and tight.
To protect your investment, wax this product after installing. Regular waxing is recommended to
add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives
that could damage the finish. Mild soap may be used to clean the Running Board.
Threaded Stud
Threaded Hole
(Fig 1) Up to 2015 driver side rear mounting
location pictured. Note: Remove plastic plugs
to locate factory threaded holes
Front
(Fig 3) Attach Driver/left Bracket to vehicle
04-15, 17 NISSAN TITAN AND 16-17 NISSAN TITAN XD CREW CAB
Driver/Left Side Installation Pictured
Front
Page 2 of 4
(Fig 2) 2016-on driver side rear mounting location
pictured. Note: two factory threaded holes only
8mm x 30mm Hex Bolt
8mm Lock Washer
8mm x 24mm Flat Washer
Or
8mm x 24mm Flat Washer
8mm Nylon Lock Nut
8mm x 30mm Hex Bolt
8mm Lock Washer
8mm x 24mm Flat Washer
SR2 RUNNING BOARD
(2) Threaded Holes
Front
11/24/17 (RA)