Insignia 9246MF7010 Manual Del Usuario página 14

Note Write protection setting methods: enter into ALL-100 upgrading interface "AUTO", tick off
option "Config", click item "config Setting", set option "Protect" as "All Protect" and
"SRWD" as "Enable", then press "OK" to complete write protection setting;
Please make sure option "Config" is ticked off during software upgrading process and reset
write protection after ALL-100 upgrading software is opened each time;
8 HDCP KEY upgrading processes
(1) Connect with upgrading jig;
(2) Operate ISP_ToolV1.04.exe shown as Fig. 2:
(3) Click button 'open' to load encrypted KEY file;
(4) Click button 'Run' to perform KEY upgrading, upgrading information will be listed within
information frame after upgrading completed.
9 EEPROM initialization (Only used if necessary)
Detailed procedures: Press key IR POWER/KEYPAD POWER to turn on the TV set, keep
pressing key INPUT SOURCE on the panel before SHOW LOGO until indicator light on the panel
turns into red, then press keys MENU, VOL+, CH+ in turn at 2S interval, indicator light on the panel
turns into blue and the TV set turns into STANDBY mode after a while, now RESET EEPROM
succeeds; if key order or key value is wrong, or no key is pressed within 2S interval, previous setting
will keep on being performed and EEPROM will not be cleared out as well.
All manuals and user guides at all-guides.com
Aligment Instructions
Fig. 2 ISP tool
Address: 0x1B0000
Information frame