Assembly And Operation - Oh!FX MINI CLUB M-CLUB-1 Manual De Instrucciones

ASSEMBLY AND OPERATION

Placement: Before you fi x the machine, make sure that you have enough height or space
around for the confetti or streamers which will be projected, preventing that they impact
against anything or anyone, and can cause damage.
1. Place the machine on the fl oor, fi xed on a truss using clamps (not included) or fi xed to the
wall by using the other anchor points for attachement (7).
2. Fix the output setting (3) desired (single or double tube) by threading it to output thread (2).
Tighten it hard with a wrench.
3. Connection of the air input (to an air compressor or CO2 bottle):
3.1 – Air compressor: Connect the air tube or hose (8) from the air input (1) to the air
compressor. Turn On the air compressor and check that the pressure is between 6 - 8
Bar (87-116 PSI). Check that there is no air leak.
3.2 – Using a CO2 bottle: Attention! This option is only valid when using CO2 bottle of
Gas, NOT liquid, that is, the bottles without the pipe inside, just as the ones used for
draft beer in a Bar. But remember that you need to reduce the high pressure contained
inside the bottle. To do this, connect a gas regulator to the CO2 bottle. Connect then
the air tube/hose (8) from this gas regulator to the air input of the machine (1). Open
the CO2 cylinder and check that the pressure is between 6 - 8 Bar (87-116 PSI).
Check that there is no air leak.
4. Connect the power plug (5) to the electricity source or power control.
5. You can use diff erent control systems to fi re the Mini Club machine (eg: 1 CHANNEL FX
PUSHER, 1 CHANNEL DMX SWITCH, etc.). Once connected, do a quick test by shooting
the machine (without confetti inside the tubes). If the connections are correct, you will hear
the noise of the shot. If the machine has no air inside, you will hear a "click" noise from the
valve when opens.
6. Place the tubes which will fi re the confetti/streamers to the machine and orientate to the
desired angle or direction. Secure the position by tightening strongly the nuts.
7. Fill up the tubes with the desired confetti and/or streamers and shoot the machine.
COMMENTS
• In order to activate and shoot the machine, you better use a control with a push-button
(fl ash) system instead of an On/Off switch. In this way, the valve gets automatically closed
when you release the pushbutton, and do not makes a noise for the loss of air.
• If you keep the machine connected to the air compressor, the machine will get full of air
again in few seconds. Wait until the machine has been reloaded to make your next shot.
3
INSTRUCTION MANUAL