Publicidad
Idiomas disponibles
Idiomas disponibles
SETUP AND OPERATION
1. Attach the clamps (not included) to the main anchor points (3) if you wish to fi x the machine
on a truss structure, and place the machine in the desired place. Secure the machine with
a safety cable suitable for the weight of the machine. For this purpose, use any of the
anchor points to attach safety cables (4).
2. Plug the machine with a powercon cable (not included) into the Power In connector (5). If
you want to use several machines at the same time, link them by using a Powercon cable
male-female connected on the Power out connector (6) of the 1st machine.
3. Filling the machine: Load the snow machine with the desired snow paper or small confetti.
Make sure that the consumable to use is small enough to fall through the grill. Never
exceed the maximum level shown on the indicator of Maximum load level (2) as you risk
to clog the machine.
4. Loosen the buttons (10) fi xing the grill plate and slide the grill plate (9) to adjust the size of
the consumable you are using, to the holes of the grill plate.
5. Adjust the speed regulator (8) to the desired intensity of snowfall. You can increase of
decrease the intensity of the snowfall by either adjusting the speed regulator (8) or also by
opening more or less the grill plate (9).
6. You can also adjust the intensity of the snowfall by using a Dimmer device connected into
the Input of the machine.
7. Blizzard machine will be activated as soon as it receives electricity current. You can
use diff erent control systems to activate the machine (eg: 1 CHANNEL FX PUSHER, 1
CHANNEL DMX SWITCH, etc.).
GENERAL CAUTION FOR BLIZZARD MACHINE
BLIZZARD machine has been designed for the described purpose. Any other use diff erent
from the written will disclaim Oh!FX (CONFETTISHOTS SLU) of all liability and warranty.
•
Use only the consumables intended for that specifi c use, and duly certifi ed.
•
In case of malfunction, do not attempt to disassemble the machine and contact the
distributor or manufacturer. Any manipulation may exclude the warranty
•
Do not wet the machine. To clean it, use a damp cloth and dry it immediately.
•
Only one adult and qualifi ed person must manipulate the machine.
3
INSTRUCTION MANUAL
Publicidad
