Multi-Temperature Models; All Models - Transtherm Caves Mas 1T Modo De Empleo

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Te m p e rat u re settings for mu l t i - t e m p e rat u re models
The temperat u re control(s) and setting(s) are adjusted from your wine cab i n e t 's
settings panel, as shown below
Te m p e rat u re setting for hot
Te m p e rat u re setting for cold
t h e rm o s t at (top of cab i n e t )
t h e rm o s t at (bottom of cab i n e t )
Model
Display of lowest temperature
in cabinet
Display of highest
temperature in cabinet
- the temperat u res are set by the use of the hot and cold therm o s t at setting bu t t o n s .
S t a n d a rd Settings for mu l t i - t e m p e rat u re models
To obtain a temperat u re ra n ge of 8°C to 18°C in your m u l t i - t e m p e rat u re
c ab i n e t :
- Tu rn the hot therm o s t at button (on left hand) until the mark mat ches up with
the fi g u re 18
- Tu rn the cold therm o s t at button (on right hand) until the mark mat ches up with
the fi g u re 8.
Te m p e rat u re Adjustment for mu l t i - t e m p e rat u re models
If the load set up or the location of your cabinet calls for it, you can adjust the
t e m p e rat u re settings up and dow n .
- Tu rn the cold therm o s t at button (on right hand) until the mark mat ches up with
the lowest temperat u re you re q u i re in your cabinet (this will be the
t e m p e rat u re at the bottom of the cab i n e t ) .
- Tu rn the hot therm o s t at button (on left hand) until the mark mat ches up with
the highest temperat u re you re q u i re in your cabinet (this will be the temperat u re
in the upper compartment of the cab i n e t )
- You can adjust either of these temperat u re s , thus va rying the temperat u re
b ra cke t
You can never ch a n ge a mu l t i - t e m p e rat u re cabinet into a signle temperat u re
cabinet. The hot temperature must control knob should always be set at
a higher temperature than the cold knob.
All manuals and user guides at all-guides.com
Hot circuit operating
indicator (red)
On/Off
switch
Cold circuit ope-
Test
rating indicator
Button
(green)
P12
Te m p e rat u re Settings for all models
°C / °F Conversion Table
°C
°F
6
42
8
46
10
50
12
54
14
57
16
60
18
64
20
68
It may be that despite the re c o m m e n d ations in this manu a l , you still do not
a ch i eve quite the desired temperat u re. Eve ry situation is unique, and it may
be that a few slight corrections are needed.
The setting values are not in °C but in index values. An index value is ro u g h ly
equal to one degree Celsius.
You will need to wait ap p rox i m at e ly 48 hours befo re noticing the effects of
a temperat u re adjustment.
P13

Publicidad

Tabla de contenido
loading

Tabla de contenido