Toparc MINI 200L Manual Del Usuario página 4

Translation of the original instructions
OPERATING INSTRUCTIONS
TECHNICAL DATA
Light Source
Luminous Power
Operating time
Battery Specification
Charging Time
Charging Input
Degree of protection
Operating temperature
WARNING
• Do not open the device.
• Do not look directly into the light emitting lamp - Risk of eye injuries!
• Do not operate in direct sun light or extreme temperature conditions.
• Operating temperature, -10°C to +40°C.
• Keep away from children! Children should be supervised in order to ensure that they do not play with the device!
OPERATING & CHARGING PROCEDURE
• STYLO LAMP - Operating mode :
- Press the button for the first time, the upper LED lights up.
- Press the button a 2nd time, the main LED lights up at low intensity (60 Lm).
- Press the button a 3rd time, the main LED lights up at high intensity (200 Lm).
- Finally, press the lamp a 4th time to turn it off.
• Connect the lamp with the supplied USB charging cable to recharge it.
• A red LED lights up to indicate the charge.
• The charge is complete when this light turns green.
• If the charging indicator does not light up, disconnect and then reconnect USB cable.
• Always use the USB cable recommended for this lamp.
• Using a non-recommended cable can cause a fire and destroy the lamp
• Charge the lamp for 4-5 hours before first use.
• Charge the lamp to 100% before storing it for a long time.
SAFETY INSTRUCTIONS
• Do not use the device if there is damage to the housing, plug or cable. Consult your local authorized specialist!
• Do not open the device! Repair work and replacing the rechargeable battery pack may only be carried out by electri-
cians.
• Carry out cleaning tasks only when the mains plug is removed from the mains power!
• There is a risk of short-circuit. Repairs on the device may only be carried out by commissioned and trained persons.
Please contact your nearest authorized branch.
• Protect the battery against heat, e. g., against continuous intense sunlight, fire, water, and moisture. Danger of
explosion.
• If the battery is damaged or not used correctly. Fluids can leak from the battery. Avoid contact with these. Leaking
battery fluids can lead to skin irritation or burns. Rinse off with water if you should come into contact. If the fluid
gets into your eyes,make sure you get medical help.
• The lamp is not allowed to be placed on a surface while the light is being switch on.
4
MINI INSPECTION LAMP 200L
Keep this instruction manual for future reference or for subsequent possessors.
High power COB LED
ca. 200 lumen ‒ High light
ca. 60 lumen ‒ Low light
ca. 120 lumen ‒ Top light
ca. 2h ‒ High light
ca. 6h ‒ Low light
ca. 3h ‒ Top light
Li-Ion 3.7 V, 700 mAh, 2.59 Wh
ca. 2 h
DC 5V 1A
IP 20 , IK 07
-10 °C to +40 °C
EN