Troubleshooting
Problem
The Battery Status LED
blinking orange.
The notebook feels too hot.
The computer takes longer during
Startup.
You forget the boot password.
The compact disc tray will not
open when there is a disc in the
tray.
The DVD regional codes can no
longer be changed.
Unwelcome numbers appear
when typing.
All manuals and user guides at all-guides.com
, is
Low Battery. Plug in the AC power source. If the computer doesn't start up immediately, turn it
off then on again.
Make sure the notebook is properly ventilated and the vent(s)/fan intake(s) is (are) not blocked.
If this doesn't cool it down, put the system into Hibernate mode or turn it off for an hour. Make
sure the computer isn't sitting on a thermal surface. Make sure you're using the correct adapter.
Data saved on the hard disk drive may be lost or damaged. Operate the scan disk or disk
defragmenter to check for any lost or damaged data.
The computer is waking up from the Hibernate mode.
If you forget the password, you may have to discharge the battery of the CMOS. Contact your
service representative for help.
The compact disc is not correctly placed in the tray. Gently try to remove the disc using the
emergency eject hole. See
The code has been changed the maximum 5 times. See
For Model A only - If the LED
Fn + NumLk key combination (see
Possible Cause - Solution
"CD Emergency Eject" on page 14
is lit, then Number Lock is turned ON. Press and release the
"Numeric Keypad" on page
Concise User's Guide
.
"DVD Regional Codes" on page 14
11).
Troubleshooting - 29
.