Technical Data; Charging Mode - Beta 1838E Manual De Uso E Instrucciones

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO

TECHNICAL DATA

LAMP
LAMP LENGTH
LIGHTING AREA LENGTH
NUMBER OF LEDS
MAIN LIGHT
CHARGE INPUT
PROTECTION DEGREE
OPERATING TEMPERATURE
BATTERY CHARGER
POWER SUPPLY VOLTAGE
OUTPUT
BATTERY
BATTERY SPECIFICATIONS
CHARGE INPUT
USE
Before using the lamp for the first time, select the operating mode as follows:
- Press the ON/OFF switch to enable the lamp.
- Press a first time to enable the MAIN light in the eco mode.
- Press a second time to switch the lamp to the normal mode.
- Press a third time to switch the lamp to the full power mode.
- Pressing a fourth time will cause the lamp to be disabled and switched off.
The lamp is fitted with an internal memory which saves the last setting before turn-off and is enabled 10 seconds after the ON/
OFF button is pressed for the last time.
After the lamp has been on for 10 seconds in the selected mode, pressing the ON/OFF switch will cause it to be SWITCHED OFF.
When the lamp is enabled again by pressing the ON/OFF switch, it will go on in the last selected mode.
The lamp comes with an extendable spring hook which allows a total opening of up to 178 cm and can be hooked to the bonnet
of any vehicle. Furthermore, it can rotate 360°, thereby providing optimal lighting conditions.

CHARGING MODE

If the battery is flat, both the light being used and the LED light next to the ON/OFF switch will be blinking.
The lamp can be charged in 2 different ways: through a USB port on the lamp or by charging the internal battery.
Charging through the USB port of the lamp above the ON/OFF button.
Connect the cable first to the lamp and the power supply, and then to the mains socket, making sure that the mains voltage is
compatible with that of the charger as stated in the TECHNICAL DATA table.
Do not use the lamp while charging.
Charge level
Turning the lamp on will cause the 3 LED lights next to the ON/OFF switch to light up, to indicate the charge level.
- 3 green LED lights: 100% charge
- 2 green LED lights: 60% charge
- 1 green LED light: 20% charge
- Blinking LED light: flat battery
While the lamp is being charged, the LED lights next to the USB socket will be blinking.
The lamp will be fully charged when the 3 LED lights will remain green.
When charging is complete, disconnect the lamp.
Charging through the USB port of the internal battery.
Remove the internal battery.
Connect the cable first to the lamp and the power supply, and then to the mains socket, making sure that the mains voltage is
compatible with that of the charger as stated in the TECHNICAL DATA table.
6
1160÷1880 mm
825 mm
50
SMD LED
eco mode ~ 500 lm - max 9h
normal mode ~ 1000 lm - max 6h
full power mode ~ 2000 lm - max 3h
DC 5V – 2000 mA (USB-C)
IP20 IK07
-10°C ÷ +40°C
100 - 240V ~ 50/60Hz
DC 5V – 2000 mA
Li-Ion 3,6 Volt 17,28 Wh
DC 5V – 2000 mA (USB-C)
EN I