Stanley IntelliSensor Plus Manual De Instrucciones página 4

Operating Instructions
Prepareing for use
1.0 Battery:
Open the battery door on
back of unit (illustration 3)
and connect a 9-volt battery
( n o t i n c l u d e d ) . I n s u r e t o
align the "+" terminal of the
9 - v o l t b a t t e r y t o t h e " + "
indicator, located inside the
battery compartment. Place battery door onto
c a s e a n d s n a p b a t t e r y d o o r o n .
Recommend to replace a new 9 volt battery
when low battery. (flashing green LED).
2.0 Turning Power On
The ON/MODE Button is located on the right
side (illustration 1) of the hand grip.
3.0 Selecting Scanner Depth Mode
1. Depress and hold "ON" button once (1x) to
select to 1/2 " read depth detection. The
1/2"mode LED will illuminate (illustration 2). The
unit will then calibrate, followed by a beep and a
green LED will illuminate.
2. `Double-click' / Depress and hold ONbutton
twice (2x) to select to 1" read depth detection.
The 1" mode LED will illuminate (illustration 2).
The unit will then calibrate , followed by a beep
and a green LED will illuminate.
3. "Triple-click"/ Depress "ON" button three
t i m e s ( 3 x ) t o s e l e c t 1 - 1 / 2 " r e a d d e p t h
d e t e c t i o n . T h e 1 - 1 / 2 " m o d e L E D w i l l
illuminate (illustration 2). The unit will then
calibrate, followed by a beep and a green
LED will illuminate.
IMPORTANT: Unit will automatically shut- off if
ON button is released following steps 1,2,3
above.
4
BATTERY DOOR
ILLUSTRATION3