Alarm Setting - Techno Line WS 9490 Manual Del Usuario

Alarm setting:

1. Press the "SET" button once to view
the alarm time, "AL" icon will display.
2. In view mode press the "
MEM/
" " button to switch the alarm
on or off. The alarm is on when the bell
symbol is displayed.
3. Press and hold the "SET" button for 2
seconds to enter the alarm time setting.
4. The alarm hour digits flash. Press
CH/ MEM/
" " or " " button to set
the hours of your desired alarm time.
5. Press "SET" once again, the alarm
minute digits flash. Press "
6. Then press "SET" once again to complete set-up
ALARM NOTE
Alarm is crescendo sound. When the alarm sounds, it continues for 2 minute and then shuts off completely.
Snooze
When the alarm sounds, press the "SNOOZE" button to silence the alarm for 10 minutes.
The snooze icon Zz will flash.
Press any button except SNOOZE to silence the alarm for 24 hours.
MIN/MAX temperature and humidity:
1. Press " " to view the minimum and maximum indoor and outdoor temperature and humidity daily
MEM/
memory
2. In this mode, press " MEM/
3. The daily max/min memory will reset automatic everyday 0:00.
Switching sensor channels:
CH/
1. Press the " " button to view the three sensor channels.
2. Press and hold for 2 seconds to clear the current channel to re-register
Add a new sensor:
1. Open the battery compartment and insert 2x AAA batteries.
2. Select a free channel with the channel switch in upper right of the battery compartment of the outdoor
sensor.
3. Press the " CH/ " button on the base station to select a free channel. Then press and hold the "
button until the station beeps.
4. Press the "TX" button in the upper left of the outdoor sensor battery compartment.
5. Close the sensor battery compartment.
WS 9490
CH/ " or
CH/ " or " MEM/ " button to set the minutes of your desired alarm time.
" 2 seconds to clear memory.
CH/ "
GB 4