Choice Of The Installation Site; Electric Connection - IARP BRERA Instrucciones De Uso

Modello - Model - Modèle
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
5.

CHOICE OF THE INSTALLATION SITE

Read the manual carefully and adhere to the contents before installing and using the appliance.
In selecting the place of installation, ensure that the following instructions are observed, this being vital for proper and troublefree
working of the cabinet:
• Do not install the cabinet in the vicinity of heating radiators or other heat sources.
• Do not install the cabint where it is exposed to direct sun light (e.g. through windows).
• Do not expose the refrigeration unit to air currents from fans, open doors, conditioning units.
• Keep the air intake and outlet area around the plinth area of the cabinet clear of cartons and other obstacles.
• It is necessary taht the condensing unit obtains a good circulation of air around it; also the area around the condensing unit should
not be obstructed by boxes or other objects; keep a distance from the wall of 10 cm. at least.
• Check in advance (in the event of a new installation), compliance with minimal safety standards, positioning and operation of the
vending machine, detecting the environmental conditions (temperature, humidity, lighting) and suitability of the operating spaces.
6.

ELECTRIC CONNECTION

• If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must be left to stand for at least three
hours before being started to allow the lubricating oil to settle in the compressor. Failure to do so can cause total destruction of
the compressor refrigerating system.
NOTA - The technical support is responsible for your vending machine installation and will therefore have to make sure
that the power supply system is in compliance with the safety regulations in force. If in doubt, do not continue
the installation and ask qualified and skilled personnel to carry out a complete check on your machine wiring
system. Also make sure that the electric network to which your vending machine is connected has suitable
specifications for the maximum load required by the machine and indicated in the data plate.
ATTENTION! Make sure that the electrical plug is easily accessible even after installing the machine.
ATTENTION! The cable should be fully extended and located where it is unilikely to be struck, caught
or stepped on, away from water and the other liquids and heat sources and must not be damaged.
ATTENTION! In case of breakage of the power cable of the cabinet, it must be replaced by the
manufacturer or by instruction it change of it.
• The electric system of the vending machine has been carried out by using components and
following criteria which guarantee the highest reliability and safety during use.
ATTENTION! Before connecting to the building electric system, be sure
that the mains voltage and frequency correpond to those reported on the
identification plate placed on the machine (± 10%).
• The mains must be protected by a high-sensitivity differential switch (In= 16A - Id
= 30 mA) and earthed. The earthing of the machine is essential and compulsory.
Apart from the connection to the electrical mains, do not carry our any other
intervention on the electrical system of the machine.
• Absolutely never use reduction units, patch cords, adapters or multiple socket
outlets to connect the counter. DIRECTLY connect the equipment to the mains.
• Follow the manufacturer's instructions to install the unit, using qualified personnel and complying with the
electrical regulations for the specific country.
The manufacturer disclaims all responsability for any damage to people or things due to
incorrect observance of this rule.
BRERA
CHELSEA
TROCADERO
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
PAGE
Air-Condi�on
2 4 / 9 6
UM000492
N° DOC