VONROC GS502AC Traducción Del Manual Original página 10

EN
• When maintaining the shredder, be aware that
although the power source is switched off, due
to the locking function of the safety device, the
shredder can still be moved.
• After every work stint, clean the machine thor-
oughly to remove all dust and debris, and repair
or replace any faulty parts.
• Keep the device, in particular the air vents,
clean at all times.
• Never spray water on the device body!
• Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition;
• Repairs and works specified in these Instruc-
tions may only be performed by qualified
authorized staff.
• Use only original accessories and original spare
parts. Components for which there are no in-
structions for exchanging should be replaced by
the manufacturer only. Using other spare parts
can result in accidents/injuries of the user. The
manufacturer will not be liable for any such
damage.
Replacing the cutting blades (Fig. F)
Before carrying out any work on the
machine, disconnect the mains plug from
the power supply.
When replacing the cutting blades, wear
protective gloves. Danger of injury when
touching the cutting blade.
Only use blades that are recommended by
the manufacturer.
Replace worn or damaged parts for safety.
Use only genuine replacement parts and
accessories.
1. Turn the knob (11) completely anti-clockwise to
open the upper body (7).
2. The machine has built in two blades (16) which
can be replaced. Loosen the two bolts per blade
with the hexagon wrench (22) to be able to take
the blade off.
3. Insert a new blade and tighten the two bolds.
4. Close the upper body and turn the knob (11)
completely clockwise.
10
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the im-
plied warranties of merchantability and fitness for
a particular purpose. In no event shall VONROC be
liable for any incidental or consequential damages.
The dealers remedies shall be limited to repair or
replacement of nonconforming units or parts.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
WWW.VONROC.COM