Machine Information; Technical Specifications - VONROC GS502AC Traducción Del Manual Original

EN
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm
cable reel, always fully unroll the cable.

2. MACHINE INFORMATION

Intended use
This shredder is developed to chop up branches,
twigs and other pruning. It can easily be reduced to
wood chips for reuse. The shredder is intended for
small to medium sized private gardens at home, it
is not intended for heavy duty use.

TECHNICAL SPECIFICATIONS

Model No.
Voltage
Frequency
Power
No load speed
Max. cutting diameter
Collection bag capacity
Weight
Protection level
Protection type
Sound power level (Lwa)
* The P40 40% operating mode means a load
profile of 40 seconds of load and 60 seconds of
idle running. Long-term operation is admissible
for practical use.
** Depending on the hardness of the wood.
*** Measured values learnt according to 2000/14/
EC & 2005/88/EC (1.60m height, 1m distance)
measurement tolerance +/- 3 dB.
8
. If you use an extension
2
GS502AC
230-240 V~
50 Hz
2500 W (P40)*
4200/min.
45 mm**
45 L
10.3 kg
IPX4
Class II
106 dB***
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2-3.
1. Feeder hopper
2. Lower body
3. Wheel
4. Foot pad
5. Frame
6. Collection bag
7. Upper body
8. Push stick
9. Overload protection reset
10. On/Off switch
11. Knob
12. Connecting pole
13. Wheel cover
14. Blade defend block
15. Blade
16. Blade bolts
17. Frame bolts
18. Spacer
19. Axle bush
20. Wheel nut
21. Nut wrench
22. Hexagon wrench
3. ASSEMBLY
Before assembly, always switch off the
machine and remove the mains plug from
the mains.
Assembling the wheels and the frame (Fig. G & H)
1. Push the connecting pole (12) through the two
lower holes of the frame (5).
2. Attach on each side of the connecting pole (12)
a spacer (18), an axle bush (19) and a wheel
(3). Then tighten with a nut (20).
3. Mount the wheel cover (13) onto the wheel (3).
4. Stand the shredder upside down (on the feeder
hopper) and fit the frame (5) to the lower body
(2) using 4 frame bolts (16) and tighten with
the nut wrench (21).
WWW.VONROC.COM