Charging Your Goal Zero Yeti; Charging From Solar; Charging From The Wall; Charging From Usb-C - GOAL ZERO YETI 500X LITHIUM Guia Del Usuario

Charging Your Goal Zero Yeti

CHARGE ME: Keep your Goal Zero Yeti plugged in when not in use. For more tips and tricks
on keeping your battery healthy, see the BATTERY 101 section (pg. 14).
When charging your Goal Zero Yeti you will notice a battery segment blinking in the
display. This indicates the current charge status. Once your Goal Zero Yeti is fully
charged, all battery segments will be lit and remain solid. As long as there is more power
going into the Goal Zero Yeti than is being pulled from the output ports, the display will
also indicate an estimated time until fully charged. This is an estimated time based on
the power input and output numbers at that time; it will gradually adjust to a shorter or
longer time as the average charge or discharge rates fluctuate.

Charging from Solar

IMPORTANT NOTE: When solar charging your Goal Zero Yeti Lithium, take note of
the voltages of the solar panels and do not exceed 22V. Individual solar panels,
or solar panels chained in series in excess of 22V cannot be used with the Goal
Zero Yeti Lithium and can cause serious damage to the unit. For help on chaining
solar panels, call our Customer Solutions Center at 888-794-6250.
Your Goal Zero Yeti has two 8mm charging ports. One is located on the left side of the
faceplate. The other is located on the back in the bottom right hand corner. Both 8mm
ports are designed to work with Goal Zero solar panels and are capable of taking in
120W of solar.
NOTE: You can only use one 8mm input at a time to charge your Yeti. If you plug into both
8mm input ports at the same time, the Yeti will always default to the front 8mm port.
4
1. Place your solar panel where it will get as much direct sunlight as possible.
2. Insert the blue-ringed plug from the panel into either input port on the Yeti. You
will know the Yeti is charging when the blue LED light next to the input port lights
up, and the battery segments in the LCD battery display are blinking. The Yeti is fully
charged when all battery segments stop blinking and remain solid.
3. Some Goal Zero panels are chainable to provide more power to your Yeti and
reduce solar charge times. The input port is capable of taking in 120W of solar.

Charging from the Wall:

Using the included AC Wall Charger, plug your Goal Zero Yeti into any wall outlet. You will
know the Goal Zero Yeti is charging when the blue LED light next to the input port turns
on, and battery segments in the battery display are blinking. The Goal Zero Yeti is fully
charged when all battery segments stop blinking and remain solid. The Goal Zero Yeti
should recharge from the wall in about 9 hours.
1. The AC wall adapter comes in two pieces. Connect the two pieces by plugging the
cable into the box.

Charging from USB-C:

Charge your Yeti using the 60W USB-C PD input/output port by plugging into any USB-C
charger (sold separately).
NOTE: You can plug into both the 8mm input port and the USB-C input/output port at
the same time to receive up to a combined 180 watts.
NOTE: For additional charging options such as car charging and fast charging, visit
www.goalzero.com/shop/yeti-accessories.
5