Installing The Module - Allied Telesyn AT-BMGMT Guía De Instalación Rápida

All manuals and user guides at all-guides.com

Installing the Module

To install the module, perform the following procedure:
1. Power off the switch by disconnecting the AC power cord from the switch.
If the switch is connected to a redundant power unit (RPU), disconnect the
DC cable connection to the switch.
Caution
The switch must be powered off before installing or replacing the
module. Installing the module with the switch powered on can damage
the module.
Note
If you have created a stack of AT-8324SX switches, you must install the
AT-BMGMT Management Module in the bottom or the top switch in the
stack.
2. Using a flathead screwdriver, loosen the screws securing the faceplate to
the top expansion slot on the switch and remove the faceplate.
Caution
The management module must be installed in the top expansion slot on
the switch. Do not install the module in any other expansion slot.
Note
Keep the original faceplate for future use. If you should remove the
module, replace the faceplate to prevent dust and debris from entering
the unit and to maintain proper air flow.
4
Figure 2 Removing the Faceplate