Install The Batteries - Logitech 966167-0403 Manual Del Usuario

Install the Batteries

The Logitech ® Cordless Presenter
Install the batteries before installing the software.
1. Remove the battery door (picture 1). Place your thumb
on the indentation at the top of the battery door. Gently press down
and carefully slide the door off.
2. Insert the batteries (picture 2). Use the diagram inside
the battery compartment to install the batteries correctly.
3. Replace the battery door (picture 3). Align the battery door
in the groove that outlines the battery compartment. Carefully slide
the battery door forward to secure it. Do not force the door;
it should slide easily into place.
Battery Status LED
• The Battery Status LED above the Back (right) button is green
for two seconds after the presentation device is switched on.
• The Battery Status LED turns red and blinks slowly when battery
power is low. (Replace the batteries.)
• The Battery Status LED is red continuously when battery power
is nearly gone. (Replace the batteries immediately.)
Battery Life
When not in use, make sure to move the Mode Switch to the Off
position to conserve battery power. Depending upon usage, battery life
is estimated to be from 60-to-100 hours.
™ uses two AA alkaline batteries.
1
2
3
3
English