Telstar TAPU200210MD Manual De Instrucciones página 18

Technical Parameters
1. The performance parameters in the table are measured before delivery and are for reference only.
2. Due to product improvement, the following parameters may be changed and shall refer to the product
nameplate parameters.
3. The applicable area is according to the theoretical value calculated by (0.07 ~ 0.12) x CADR particulate
matter; with the use of different environments or outdoor pollution and other factors, the applicable area will
also change.
4. Purifying principle: The air purifier blows air into the machine and filters the air through the built-in filter core.
It can mainly play the role of filtering dust (such as PM2.5), formaldehyde, odor, sterilization and others.
Fault self-detection
Before you ask for maintenance, please check according to the table below.
Problems encountered
Purifier cannot run
The effect is bad to
eliminate smoke and
odor
Filter cleaning light does
not extinguish
It is hard to eliminate the
odor and smoke
Please send it to repair in case of the following:
1. If the operation is abnormal or the machine does not operate, and the above method is invalid;
2. Substances or water from the outside have entered and abnormal operation has occurred.
Reasons
- It is possible that the power cord is
not plugged or poor contact with
power cord
- May not turn on the power switch
- It is possible that the filter is not
installed in place and safety switch is
not triggered
- It is possible that the filter assembly is
not installed well
- It is possible that the filter assembly
has reached the end of life
- It is possible that the air inlet is
blocked by foreign matter
- It may be that the "UV" button is not
long pressed for 3 seconds after the
filter assembly is replaced.
It may be that the filter assembly is
also wrapped in a packaging bag
- Please connect power and make
good contact
- Please turn on the power switch
- Please properly install the filter and
buckle the back cover
- Please properly install the filter
assembly
- Please replace the new filter assembly
- Please remove foreign matter from
the air inlet
- After cleaning the filter assembly, long
press the "UV" button for 3 seconds
- Please remove the packaging bag
outside the filter assembly
18
AIR PURIFIER
TAPU200210MD
Solutions