Telstar TPG020210YK Manual De Instrucciones página 12

GAS
COOKTOP
TPG020210YK
Choose proper place
Make sure air can go into the room easily so that the flame is on the best condition.
Pay attention to ventilation, making wind-in opening more than one and the square
should not be less than 100cms.
The model without safety device =s square of vent should be at least 200cms.
The wind-in opening should be near the floor, it would be better face to vent window.
The air will come from other room (but not bedroom or any dangerous places), in this
case, keep the door open.
Burning resultant discharge
Vent cover should be connected to outdoors (as shown on picture 8)
You may also use blower the efficiency should reach to 3-5 times kitchen air current
quantity (as shown on picture 9)
As above refer, If only the room with proper vent can it be installed blower.
INSTALLATION
Remarks
In order to install gas nob, you should first put the template on the cooktop, then put
the appliance in after.
REMEMBER:
The free space under the appliance and over it should not be less than 30mms.
From wall to the appliance, the distance should not be less than 35mms.
If a ventilating hood is provided, distance from the working top to the bottom of the
hood should not be less than 650mms.
For not built-in structure design there should be a heat insulation device between the
appliance's bottom and other units.
For built-in structure design the distance between the appliance and the oven should
not be less than 30mms, both should be connected to gas individually.
5