N-Gear Let's Go Party 52 Manual De Usario página 4

Bluetooth pair and connect
● Turn off any Bluetooth devices previously paired (linked) with this unit.
● Turn on the Bluetooth features on your phone or music player.
● Turn on and set this unit to Bluetooth mode. The flashing blue light BT on LED display
indicates it is in pairing mode.
● Set your phone or music player to search for Bluetooth devices.
● Select "LETSGOPARTY-52" from search results on your phone or music player.
● Select OK or YES to pair this unit with your phone or music player.
● If protected, enter 0000 for passkey steady blue light indicates successful connection.
TWS (True Wireless Stereo) mode
1) Turn on speakers and select INPUT modes as Bluetooth.
2) Turn on the Bluetooth feature on your mobile phone to search for Bluetooth devices and
select "LETSGOPARTY-52" from the search result. Select OK or YES to pair this unit with your
mobile phone and a steady BT in display will indicate a successful connection. Once
connected you can play music from your mobile phone.
3) Turn on another "LETSGOPARTY-52" if you have, and select Bluetooth mode. Press and hold
" " key on speaker set for 2 seconds and "
When the display light is "
( The "LEFT" channel will be the speaker unit of frist default connection with Bluetooth devices,
the other speaker connnected with Bluetooth devices will be the "RIGHT" channel.)
4) Press " " key on the speaker unit for 2 seconds . Turn off the TWS features when "
is displayed.
Note : Step 2 is normal BT cell phone connection ( no TWS )
BATTERY
When the battery level is full: Greenlight
When battery level is low: Red light. Beware: Please charge when the battery level is too low,
otherwise the speaker will turn off for protection.
" or a tone is heard from another device, the TWS is established.
4
" will be displayed.
"