Maintenance - Kunft KCHS4852 IX Manual De Instrucciones

2.2.3. Troubleshooting
Fault Possible Cause
Light on, but motor Fan switch turned
does not work off.
Fan switch failed.
Motor failed.
Light does not work, House fuses blown. Reset / Replace fuses.
motor does not work
Power cord loose
or disconnected.
Oil leakage One way valve and
the outlet are not
tightly sealed
Leakage from
the connection of
chimney and cover.
Lights not working Broken / Faulty
globes.
Insufficient suction The distance
between the cooker
hood and the gas
top is too far.
The Cooker hood The fixing screw
inclines not tight enough.
Solution
Select a fan switch
position.
Contact service center.
Contact service center.
Refit cord to power
outlet.
Switch power outlet on.
Take down the one way
valve and seal with
sealant.
Take chimney down
and seal.
Replace globes as per
this instruction.
Refit the cooker hood to
the correct distance.
Tighten the hanging
screw and make it
horizontal.
14
visor cooker hood

2.3. Maintenance

Changing and cleaning the filter:
Remove the filters as shown in the instructions of Picture 10;
• You can clean the filter through the following method:
1. Soak them for about 3 minute in hot water (40-50 degrees) with a
grease loosening detergent, and brush it gently with a soft brush.
Please, do not apply too much pressure to avoid damaging it.
2. It can be put in the dishwasher with detergent, set the tempera-
ture at around 60 degrees.
• Please do not use abrasive detergents for they will damage
the hood;
• Make sure that the hood is switched off before cleaning it;
• Clean the filters after approximately 30 hours of use, or at least
once a month.
INSTALLING GREASE MESH FILTERS
• To install filters for the following four steps .
- Angle the filter into slots at the back of the hood.
- Push the button on handle of the filter.
- Release the handle once the filter fits into a resting position.
- Repeat to install all filters.
EN
KCHS4852 IX
KCHS4852 WH
15