Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
If a spark arrestor is used, it should be main-
tained in effective working order by the opera-
tor.
FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
Your drill press has been designed for only one
purpose, mow grass, any other intended use is
strictly forbidden.
2
5
1. BLADE CONTROL.
2. RECOIL STARTER.
3. CUTTING HEIGHT ADJUSTMENT LEVER.
4. GRASS CATCHER (PP921 & PP1021 only).
5. SIDE DISCHARGE CHUTE.
6. MULCH PLUG.
16
1
3
4
6
ASSEMBLY INSTRUCTIONS
ASSEMBLY
NOTE: This unit is shipped without gasoline
or oil in the engine. Fill up with gasoline and
oil as instructed in the accompanying engine
manual BEFORE operating your mower.
HANDLE
1. Remove any packing material which may be
between upper and lower handles.
a. Remove wing nuts and carriage bolts from
handle as shown in figure 1. Do not loosen or
remove adjacent hex head screws.
b. While stabilizing mower so it doesn't move,
pivot upper handle up as shown in figure 2. Do
not crimp cable while lifting the handle up.
Fig.1
2. Remove the T-bolts from the handle brackets
as shown in figure 3.
3. Follow the steps below to complete handle
assembly:
a. Pull upward on the handle until holes in
lower handle (shown in Figure 3 deck cutaway)
line up with holes in handle bracket (fig. 4).
NOTE: When pulling upward on handle, make
sure to not pull handle all the way out.
b. Insert the T-bolts removed earlier through
the handle brackets and lower handle and
tighten securely to secure the handle in place.
Fig.3
Fig.2
B
A
B
Fig.4
Publicidad
Tabla de contenido
