Operating Instructions; Product Description; Product Usage - Kunft KBIO4445 Manual De Instrucciones

2. OPERATING INSTRUCTIONS

2.1. Product Description

Cooling fan
A tangential cooling fan is fitted inside of this oven to stabilize its
internal oven temperature and lower the external surface temperature.
After the oven has been used, the cooling fan will run on for a period
of time until the oven is sufficiently cooled.
Control panel
Depending on the oven model, individual details may differ.
Oven programmer / timer display
1. Oven function selector knob
2. Indicator light
3. Oven programmer
4. Oven operating light
5. Thermostat control knob
Dimensions
Height: 590 mm
Width: 595 mm
Depth: 520 mm
• 6 functions
• Oven capacity: 51 litres
• Thermostatically controlled grill
• Cooling fan
16
built in oven
Oven timer
1. If you do not need to use the oven timer,
set it to "ON" and connect your mains
supply. See the picture.
2. If you need to use the oven timer, turn
the timer knob as desired, then choose
a time between 0 and 120 mins. The
oven's power will shut down when the
timing finishes.
IMPORTANT: the oven will power off when the alarm is silenced. If
you have finished cooking, then you should turn the oven function
selector and thermostat control knob to 0.

2.2. Product usage

Installation
Electrical connection
Before connecting the oven, make sure that the supply voltage
marked on the rating plate corresponds with your mains supply
voltage.
WARNING: THIS OVEN MUST BE EARTHED.
• A suitable disconnection switch is to be incorporated in the permanent
wiring. The switch is to be of approved type and positioned in
accordance with local wiring and electrical rules and specifications.
The switch must have 3 mm air gap contact separation in all poles,
in the active (phase) conductor of the fixed wiring.
BROW
MAINS LIVE L
YELLOW / GREEN
EARTH
POWER
BLUE
NEUTRAL N
SUPPLY
• To connect the oven power cord, loosen and remove the cover on
the terminal block, in order to gain access to the contacts inside.
Make the connection, securing the cord in place with the cable
clamp provided and then immediately close the terminal block
cover again.
• If you have to change the oven power cord, the earthing (yellow/
green) conductor must always be 10 mm longer than the line
conductors.
• The installation must include 1.5 m of free cable within the enclosure
for ease of installation and future maintenance.
• The mains cable must not touch any hot metal.
• Care must be taken to ensure that the temperature of the mains
supply cable does not exceed 50º C.
EN
KBIO4445
POWER CORD
17