Cage Assembly Instructions - IMPEX MARCY PRO PM-5108 Manual Del Usuario

CAGE ASSEMBLY INSTRUCTION
Tools Required for Assembling the Machine: One Adjustable Wrench and Allen
Wrenches.
NOTE: It is strongly recommended that two or more people assemble this machine to
avoid possible injury.
STEP 1 (See Diagram 1)
A.) Do not tighten Nuts and Bolts until instructed to do so.
B.) Attach the Left Vertical Frame (#1) onto a Base Frame (#3). Secure it with two M10 x 3
1/8" Allen Bolts (#48), four Ø ¾" Washers (#55), and two M10 Aircraft Nuts (#57).
C.) Attach a Diagonal Support (#4) to the Left Vertical Frame and the Base Frame.
D.) Secure the Diagonal Support to Left Vertical Frame from top with one M10 x 2 ½"
Carriage Bolt (#45), one Ø ¾" Washer (#55), and one M10 Aircraft Nut (#57). Secure it
from side with one M10 x 2 ¾" Carriage Bolt (#44), one Ø ¾" Washer (#55), and one M10
Aircraft Nut (#57).
E.) Secure the Diagonal Support to the Base Frame with one M10 x 1" Allen Bolt (#53) and
one Ø ¾" Washer (#55).
F.) Repeat B, C, D, and E to install the Right Vertical Frame (#2), one Base Frame, and one
Diagonal Support together.
G.) Connect the two Diagonal Support together with a Cross Brace (#5) in the mid-span.
Secure each end of Cross Brace with two M10 x 2 ¾" Carriage Bolts (#44), one 4 ¾" x 2"
Bracket (#18), two Ø ¾" Washers (#55), and two M10 Aircraft Nuts (#57).
H.) Attach the Chin-up Bar (#6) to the Left and Right Vertical Frame. Secure each end with
two M10 x 1 5/8" Carriage Bolts (#46), two Ø ¾" Washers (#55), and two M10 Aircraft
Nuts (#57).
©IMPEX INC.
6
www.marcypro.com