Rampage AV-990 Manual De Operación página 6

OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
1
ON-OFF SWITCH/VOLUME CONTROL
Rotate this knob to the right to turn the unit on.
Continue rotation until desired volume level is obtained.
2
LEFT/RIGHT BALANCE CONTROL
Rotate this knob to the left or right to obtain the desired
balance between the left and right channel speakers.
3
FRONT/REAR FADER CONTROL
Rotate this knob to the right or left to obtain the desired
balance between front and rear speakers in 4 speaker
installations. When used in conjunction with the Left/
Right Balance Control
balance capability.
4
3-BAND EQUALIZER CONTROLS
These controls permit precise tone adjustment in
three frequency ranges from bass (100 Hz) to mid-
range (1 KHz) to treble (10 KHz). Moving each control
upward will emphasize that range, while moving it
downward will de-emphasize that range. Each slide
control is capable of varying the response from the
mid-position (flat) setting upward by 12 dB or down-
ward by 12 dB, for a total variation of 24 dB.
5
AM/FM BAND SELECTOR
Each time this button is pressed, the radio band
5 5 5 5 5
changes. The selected radio band is shown by the
indicator for AM or FM on the display panel.
All manuals and user guides at all-guides.com
1 b q 5 6 b r
3 9
2
, you have full 4-way stereo
bl 8 b o
b n b m
REW FF
b s b t 4 b p
6
FM LOCAL/DISTANT SELECTOR
This two position switch is incorporated to allow
maximum reception in both weak and strong FM
signal areas. For normal reception conditions
when receiving a wide range of signals including
weak or distant stations, the switch should be in the
released (out) position, which will allow maximum
signal to the receiver. When in an extremely strong
(local) signal area, push the switch in to the Local
setting. This will eliminate weak signals and sup-
press overly strong signals so as to avoid overload-
ing the receiver input. When moving out of the
strong signal area, return the switch to the Distant
(out) setting.
NOTE: The Local/Distant Selector only affects FM
signals, and will have no effect on AM
reception.
7
MANUAL TUNING CONTROL
Rotate this knob to the left or right to select a radio
station. The selected frequency will be shown by
the digital read-out on the display panel.
8
AM ANTENNA TRIMMER
It is very imporatnt to adjust the Antenna Trimmer
for optimum AM reception. The antenns trimmer is
located at the back of the cassette deck behind the
the tape door. Adjust it as follows:
7
2