Care And Maintenance - Rampage AV-990 Manual De Operación

SPECIFICATIONS SPECIFICATIONS SPECIFICATIONS
SPECIFICATIONS SPECIFICATIONS
Size:
Operating Voltage:
Output Power:
Output Wiring:
Output Impedance:
Tuning Range:
Sensitivity:
FM Stereo Separation:
Tape Frequency Response:
Tape S/N Ratio:
Wow & Flutter:

CARE AND MAINTENANCE

CARE AND MAINTENANCE
CARE AND MAINTENANCE CARE AND MAINTENANCE CARE AND MAINTENANCE
The radio portion of your new sound system does not require any maintenance. We recommend you keep
this manual for general reference of the many features found in this unit.
As with any cassette player, the cassette section of this sound system does require a minimum of
maintenance to keep it in good working condition. The following simple care and maintenance suggestions
should be followed to prevent malfunctions of the cassette system.
Cassette Care:
1. Purchase a cassette cleaning kit from your local
retail store. Use it! At least every 20 to 30 hours
of operation you must clean the cassette mecha-
nism. A dirty cassette player will have a poor
sound.
2. Do not use cassettes that exceed 45 minutes of
play on each side.
3. Do not insert a cassette that appears to be broken,
twisted or dirty or with loose or torn labels on it.
4. Always keep your cassettes away from direct
sunlight or exposure to sub-freezing conditions. If
7 7 7 7 7
a cassette is cold, allow it to warm up before use.
5. Do not keep a cassette in the player when not in
use.
All manuals and user guides at all-guides.com
7" W x 2" H x 5-1/2" D
178mm x 50mm x 137mm
12 volts DC, negative ground
50 watts maximum
( 25 watts x 2 channels)
Floating-ground type designed for 4 speaker use.
May also be used with 2 speakers.
Compatible with 4-8 ohm speakers
AM: 530-1,720 KHz.
FM: 87.5-107.9 MHz.
AM: 15 uv.
FM: 2.5 uv.
30 dB
50-10,000 Hz.
50 dB
0.15% WRMS
* Specifications are subject to change without notice.
6. Before inserting a cassette in the player, check
that the tape is tightly wound on the reels. Take
up any excess slack using a pencil to turn the
drive hub in the cassette (see diagram below).