Items Supplied; Proper Use; Technical Data - EINHELL Expert TE-RO 55 Manual De Instrucciones

Anleitung_TE_RO_55_SPK8__ 14.11.2016 13:31 Seite 26
GB
Remove the debris with a long stick and not with
your fingers.
Let the router run to a complete stop before
n
removing the workpiece or setting down the tool.
Always cut on a counter-rotating basis.
n
Watch out for the reaction torque of the tool,
n
especially if the router becomes jammed.
When you have finished your work, slide the tool
n
back to starting position.
Use only properly sharpened routing cutters.
n
Clamp the routing cutter by friction-locking.
n
For deep cuts, carry out the work in several
n
steps
according to the material in question.
Be sure to use only routing cutters which have
n
the
correct shaft diameter and are suitable for the
working speed of the router.
Do not lose these safety regulations.
2. Layout/Items supplied
1. Extractor adapter
2. Routing shoe
3. Wing screw
4. ON/OFF switch
5. Safety lock-off
6. Power cable
7. Handle
8. Motor casing
9. Fixing handle
10. Clamp nut
11. Speed control
12. Spindle lock
13. Safety guard
14. Revolver end stop
15. End stop
16. Wing screw
17. Pointer
18. Scale
19. Depth stop
20. Fine adjuster
21. Parallel stop
22. Open-ended wrench
23. Clamp
24. Compass point
25. Guide sleeve
26

2.2 Items supplied

Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!

3. Proper use

The router is ideal for machining wood and plastic
and also for cutting out knots, cutting grooves,
removing recesses, copying curves and logos, etc.
The router must not be used for machining metal,
stone, etc.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.

4. Technical data

See warranty card of your country.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
Wear ear-muffs.
The impact of noise can cause damage to hearing.