LD Systems MAUI 44 G2 Manual Del Usuario página 7

SYSTEM STATUS DISPLAY
4
operating conditions, the unit returns to the normal operating mode after a few minutes.
protect the system, any excessive signal level is lowered smoothly by the integrated limiter. If the limiter LED remains lit for longer or permanently,
reduce the volume level.
THRU
5
Balanced stereo line output with two male 3-pin XLR sockets for sending the input signal.
SUB OUT
6
Balanced line output with male 3-pin XLR socket for control of the subwoofer extension.
Subwoofer extension: Use either line input L or R for signal control. Both MAIN and SUB level controls and the Bluetooth unit with TWS are disabled if
HOLD TO LINK
7
To pair and connect the internal Bluetooth unit with a Bluetooth playback device, press and hold the HOLD TO LINK button for approximately 3
on the user interface for available devices. Select "MAUI 44 G2" and pair your Bluetooth device with the Bluetooth unit of the MAUI 44 G2 PA system. If
successfully paired, the Bluetooth symbol will light up permanently and playback can be started. The volume is controlled via the MAIN level control
or on the playback device.
To disconnect a Bluetooth device and set the Bluetooth unit back to standby, press and hold the HOLD TO LINK button again for approximately 3
approximately 2 seconds.
When using a single MAUI 44 G2 PA system, any stereo signal is automatically summed to mono in the Bluetooth module.
Note: The Bluetooth and TWS functions are not available if the subwoofer is used as a subwoofer extension for an existing MAUI 44 G2 PA system.
STEREO LINK / TWS
8
are used, stereo audio signals transmitted via Bluetooth can also be played back in stereo without a cable connection between the two systems
device is hereinafter referred to as the master unit, the stereo expansion as a slave unit. If the master unit with the Bluetooth playback device
frequency of about 3 Hz.
Depending on the situation, there are two different methods to pair two MAUI 44 G2 PA systems via TWS:
Situation A. Stereo system with 2 x MAUI 44 G2 and 1x Bluetooth playback device: Pair a Bluetooth playback device with the left MAUI 44 G2 system.
pressing and holding the STEREO LINK button on both devices for approximately 3 seconds within 30 seconds. The right-hand system automatically
and the slave unit the right channel.
Situation B. Stereo system with 2 x MAUI 44 G2, pair Bluetooth playback device later: Disconnect all existing Bluetooth connections on the slave unit
by simultaneously pressing and holding the HOLD TO LINK and STEREO LINK buttons on the slave unit for approximately 2 seconds. When pairing two
MAUI 44 G2 systems, ensure that the distance between the systems is no more than 15 metres. Press and hold the STEREO LINK button on the master
unit for approximately 3 seconds and press the STEREO LINK button twice in quick succession on the slave unit. Pairing occurs place automatically
within approximately 30 seconds. Pairing a Bluetooth playback device with the master unit can now be done later. The master unit transmits the
left channel of the stereo signal from a Bluetooth playback device and the slave unit the right channel.
-
7