ABB Thomas & Betts Blackburn IPC 402-8K Instrucciones De Instalación

for IPC 402-8K Insulation Piercing Connector
IPC 402-8
INSTALLING INSULATION PIERCING
CONNECTOR ON CABLE
1) Place the Insulation Piercing Connector on the
insulated cable (see Figure 1).
Insulated
Cable
Figure 1
2. Hold the Piercing Connector in place on the cable
and tighten the setscrew with an insulated wrench
until the screw head shears off (see Figure 2 and 3).
Optional Installation Tool:
Helps installer keep the connector perpendicular to
the conductor while applying torque
(see Figure 2 and 3).
Insulated Cable
Installation Wrench
(Sold separately)
OPTIONAL:
Alignment Tool
Perpendicular with cable,
alternate method
(Sold separately)
Figure 2
Figure 3
TA04672 A Page 1 of 2
INSTALLATION INSTRUCTIONS
and Neutral Connector Kit
Insulation
Piercing
Connector
OPTIONAL:
Alignment Tool
Parallel with cable,
preferred method
(Sold separately)
Setscrew
Insulation Piercing
Connector
Screw Head
Sheared off
English
INSTALLING CUSTOMER SERVICE CABLE
TO INSULATION PIERCING CONNECTOR
3) Prepare Customer Service Cable by stripping cable to
1 inch (see Figure 4).
4) Install stripped end into one of the cable ports
(Figure 4).
Figure 4
5) Once installed, tighten setscrew on back of connector
to 60 in-lbs. (see Figure 5).
Figure 5
6) For additional Customer Service Cables, repeat
steps 3 - 5 (see Figure 6).
NOTE: Customer Service Cables may enter from either
side of the connector (see Figure 6).
Customer
Service Cable
Figure 6
WARNING
RISK OF SHOCK, DISCONNECT
POWER BEFORE INSTALLATION.
IPC 402-8 N
Cable Port(s)
1"
Customer
Service
Cable
Tighten Setscrew
to 60 in-lbs.
Customer
Service Cables