Wall Installation - Chacon 34034 Manual De Instrucciones

6. Chime mode
To synchronize your detectors to your central alarm unit in chime mode, the principle
is the same as for the synchronization by zone.
1. Press the « » button, until you hear a «beep».
2. Synchronize the opening or motion detector by following the steps in point 3.

7. Wall installation

7.1. Central alarm unit (voice alarm)
Thanks to its magnetic plate at the back of the device, you can easily hang it on the
doors of your refrigerator, on your microwave... or simply leave it near you on a table
or a piece of furniture.
7.2. Motion detector
+/- 1.8-2m
When choosing a location for your motion
detector, always ensure that it is placed at a
height of 2 metres from the ground and slightly
tilted forward. Try to install it in places with the
best possible field of vision. (See diagram)
You can opt for installation with double-sided adhesive or with screws.
Tip: Don't place the detector under a heat source and avoid direct sunlight as
much as possible.
EN