Voice Recording; Resetting The Device; Safety Advice - Chacon 34034 Manual De Instrucciones

8. Voice recording

1. Press the side button until you hear a «beep».
2. Press the button for the area of your choice, you will hear a «beep» to alert you
that the message is being recorded.
3. When you finished your message, press the zone button chosen in the previous
point.
4. You will see the LED for your zone and the one with the two locks flashing.
5. Press your zone button to listen to your message again.
6. Satisfied? Confirm and press the side button.
Note: Voice recording notification is only possible in disarm mode.
9.Unpairing devices from a zone
1. Press the zone button that you want to reset until you hear a «beep».
2. After the «beep» sound, press again the zone button.
3. You will hear a different «beep» meaning that the desynchronization has worked.

10. Resetting the device

1. Remove the batteries so that the device is completely switched off.
2. Press and hold the «3» and «4» buttons at the same time for about 10 seconds.
3. Reinsert the batteries into the device to turn it on. You will hear a «beep»
indicating that the reset was successful.
Note: After restoration, all added accessories will be deleted.

11. Safety advice

• Don't mix new and used batteries.
• Please use only the type of battery specified in the manual.
• Don't leave used batteries lying around in the unit, as this may damage the unit.
• Don't place the control panel against a heat source or where it may be exposed to
direct sunlight, rain or strong light.
• The unit isn't waterproof. Don't expose it to rain or immerse it in water.
• Don't attempt to disassemble or repair the product by yourself
• Please keep these instructions in a safe place.
• Incorrect use of the battery may damage nearby objects and risk fire or serious
injury.
• Please keep batteries away from children.
• Recycle used batteries in accordance with environmental protection practices
EN