Before Use; Maintenance And Inspection - Metabo HPT UC 18YKSL Manual De Instrucciones

CAUTION:
● When the battery charger has been continuously used, the battery charger will be
heated, thus constituting the cause of the failures. Once the charging has been
completed, give 15 minutes rest until the next charging.
● If the battery is charged while it is heated because it has been left for a long time in
a location subject to direct sunlight or because the battery has just been used, the
pilot lamp of the charger lights for 1 second, does not light for 0.5 seconds (off for 0.5
seconds).
The battery will not be recharged. In such a case, let the battery cool before charging.
● When the pilot lamp fl ickers (at 0.2-second intervals), check for and take out any
foreign objects in the charger's battery connector. If there are no foreign objects, it
is probable that the battery or charger is malfunctioning. Take it to your authorized
Service Center.

BEFORE USE

Check the work area to make sure that it is clear of debris and clutter.
Clear the area of unnecessary personnel. Ensure that lighting and ventilation is adequate.

MAINTENANCE AND INSPECTION

CAUTION: Pull out battery before doing any inspection or maintenance.
1. Check the Screws
Loose screws are dangerous. Regularly inspect them and make sure they are tight.
CAUTION: Using this battery charger with loosened screws is extremely
dangerous.
2. Check for Dust
Dust may be removed with a soft cloth or a cloth dampened with soapy water.
Do not use bleach, chlorine, gasoline or thinner, for they may damage the plastics.
3. Service parts list
CAUTION:
Repair, modifi cation and inspection of metabo HPT Power Tools must be carried out
by an metabo HPT Authorized Service Center.
This Parts List will be helpful if presented with the tool to the metabo HPT Authorized
Service Center when requesting repair or other maintenance. In the operation and
maintenance of power tools, the safety regulations and standards prescribed in each
country must be observed.
English
11