Important Notes; Applications; Conformity And Approval; Operation - Monacor International JTS UF-20TB/5 Manual De Instrucciones

Pocket Transmitter for
Audio Transmission
These instructions are intended for users without
any specific technical knowledge Please read
the instructions carefully prior to operation and
keep them for later reference

1 Important Notes

The unit corresponds to all relevant directives of
the EU and is therefore marked with
•
The unit is suitable for indoor use only Protect
it against dripping water and splash water,
high air humidity and heat (admissible ambi-
ent temperature range: 0 – 40 °C)
•
For cleaning only use a dry, soft cloth; never
use water or chemicals
•
No guarantee claims for the unit and no li-
ability for any resulting personal damage or
material damage will be accepted if the unit
is used for other purposes than originally in-
tended, if it is not correctly operated, or if it
is not repaired in an expert way
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harm-
ful to the environment

2 Applications

Combined with the JTS receiver UF-20R / 5 or
UF-20S / 5, the pocket transmitter UF-20TB / 5
creates a wireless audio transmission system
The REMOSET function is a most convenient
®
feature for operating the system: Simply press
a button and, via a 2 4 GHz radio signal, the
pocket transmitter is matched to the transmis-
sion frequency selected on the receiver
For audio transmission, a microphone is
required A wide range of microphones is avail-
able from JTS: All microphones with a 4-pole
mini XLR plug are suitable

2.1 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the pocket transmitter UF-20TB / 5 complies
with the directive 2014 / 53 / EU The EU declara-
tion of conformity is available on the Internet:
www jts-europe com
Restrictions or requirements apply in the
following countries:
CZ DE
IT LT
In the Federal Republic of Germany, the pocket
transmitter requires a frequency assignment (for
which a fee is charged)
In other countries, it is necessary to apply
for a corresponding approval Prior to operat-
ing the system outside Germany, please contact
the MONACOR subsidiary or the corresponding
authorities of the respective country Links to
the national authorities can be found via the
following Internet address:
www cept org
 ECC
 Topics
 SRD* Regulations and indicative list of equip-
ment sub-classes
 EFIS and National Frequency Tables
*Short Range Devices

3 Operation

3.1 Inserting or replacing the batteries
For power supply, two 1 5 V batteries of size
AA are required If the LED
batteries are discharged and should be replaced
•
Only insert batteries of the same type and
always replace both of them
•
If the transmitter is not in use for a longer
period of time, always remove the batteries
as a precaution to prevent damage due to
battery leakage
1) Push down the unlock button (6) to open the
battery compartment cover (7)
2) Insert the batteries with the positive and
negative poles as indicated in the battery
compartment
3) Close the battery compartment cover so that
it is locked
3.2 Operation with
rechargeable batteries
Instead of batteries it is also possible to insert
two rechargeable NiMH (nickel- metal hydrate)
batteries of size AA To charge these batteries,
the charging station CH-2 is ideally suited: Leave
EL FI FR
MT PL
(2) shows red, the
13